ALT ITEM: 31215 | 1260 Series G1316A Thermostatted Column Compartment

Category: HPLC Components - Agilent | Subcategory: Column Heaters

Agilent 1260 Series G1316A Thermostatted Column Compartment

ITEM: 31215 In Stock

The Agilent Technologies 1260 Series G1316A Thermostatted Column Compartment is a
stackable temperature-controlled column compartment for LC. It is used for heating and cooling to meet extreme requirements of retention time reproducibility.

Features:

Peltier heating and cooling from 10 degrees below ambient up to 80 °C with high heating and cooling speeds for maximum application flexibility and stability.
Holds up to three 30 cm columns and optimized design gives minimum dead volumes and maximum efficiency.
Two independently programmable heat exchangers contribute volumes of only 3 µL and 6 µL.
Electronic column- identification module as standard for GLP documentation of column type and major column parameters.

Specifications:
Weight	22 lbs. (11.2 kg)
Dimensions	34.5" W x 43.5" D 14" H cm (5.5 x 13.5 x 17 inches)
Line voltage	100 – 240 VAC, ± 10 % Wide-ranging capability
Line frequency	50 or 60 Hz, ± 5 %
Power consumption	320 VA / 150W / 512 BTU Maximum
Ambient operating temperature	0–55 °C (32–131 °F)
Ambient non-operating temperature	-40 – 70 °C (-40 – 158 °F)
Humidity	< 95 % r.h. at 40 °C (104 °F) Non-condensing
Operating altitude	Up to 2000 m (6562 ft)
Non-operating altitude	Up to 4600 m (15091 ft) For storing the module
Safety standards	IEC, CSA, UL
Installation category	II, Pollution degree 2 For indoor use only
Temperature range	10 degrees below ambient to 80 °C up to 80 °C: flow rates up to 5 mL/min
Temperature stability	± 0.15 °C
Temperature accuracy	± 0.8 °C ± 0.5 °C With calibration
Column capacity	Three 30 cm
Warm-up/cool-down time	5 minutes from ambient to 40 °C 10 minutes from 40 – 20 °C
Dead volume	3 µL left heat exchanger 6 µL right heat exchanger
Communications	Controller-area network (CAN), RS-232C, APG Remote: ready, start, stop and shut-down signals, LAN via other 1260 Infinity module
Safety and maintenance	Extensive diagnostics, error detection and display (through Instant Pilot and Agilent data system), leak detection, safe leak handling, leak output signal for shutdown of pumping system. Low voltages in major maintenance areas.
GLP features	Column-identification module for GLP documentation of column type.
Housing	All materials recyclable