Category: Electrophoresis | Subcategory: Power Supplies
PCB PIEZOTRONICS I.C.P Model 482A Power Supply
ITEM: 21248 In Stock
- Free 90 Day Warranty
- One Year Upgrade Available
- Tested & Serviced Prior to Shipping
Or call (860) 691-2213
The PCB Piezotronics I.C.P Model 482A Power Supply is a single-channel, line-operated signal conditioner for ICP transducer systems. This unit provides constant current excitation to the built-in transducer amplifier and decouples the signal from the DC bias voltage.
The unit also contains provision for fault monitoring the channel, as well as provision for externally varying the constant current output over a 2 to 20 mA range. This model is factory set at 4 mA.
SPECIFICATIONS:
Performance:
- Channels: 1
- Voltage Gain: (±1 %) 1:1
- Low Frequency Response: (-5 %) <0.1 Hz
- High Frequency Response: (-5 %) >1000 kHz
- Fault/Bias Monitor/Meter: 26 V FS
Environmental:
- Temperature Range: 32 to 120°F (0 to 50°C)
Electrical:
- Power Required (Standard): DC Power
- DC Power: +32 to 38 VDC
- DC Power: 0.12 Amps
- Excitation Voltage (To Sensor): 25 to 27 VDC
- DC Offset (Maximum): <20 mV
- Constant Current Excitation (To Sensor): 2 to 20 mA
- Discharge Time Constant (0 to +50% ): 10 sec
- Spectral Noise (1 Hz): 0.71 µV/√Hz (-123 dB)
- Spectral Noise (10 Hz): 0.09 µV/√Hz (-142 dB)
- Spectral Noise (100 Hz): 0.05 µV/√Hz (-147 dB)
- Spectral Noise (1 kHz): 0.04 µV/√Hz (-149 dB)
- Broadband Electrical Noise (1 to 10000 Hz): 3.25 µV (-110 dB)
- Spectral Noise (10 kHz): 0.03 µV/√Hz (-150 dB)
Physical:
- Electrical Connector (Input, sensor): BNC Jack
- Electrical Connector (Output): BNC Jack
- Electrical Connector (DC Power Input): DIN Jack
- Dimensions: 6.3" H x 2.4" W x 11" L (16 x 6.1 x 28 cm)
- Weight: 1.51 lb (685 gm)